Custom Resolution Utility (CRU)

[ToastyX]

(12-05-2024 05:07 PM)lyndonguitar Wrote:  Hello, I am trying to create a shortcut for CRU's restart64.exe via Stream Deck. It works good, but for the prompt window that appears after "Graphics Driver Restarted, Restart Again, Recovery Mode, F8), can it be disabled? is there a command prompt switch perhaps to be made on a bat file so it won't appear?

It's in the first post:

(09-07-2012 09:06 PM)ToastyX Wrote:  

• restart.exe/restart64.exe:
  • /q - Restart without prompting (or rename the file to restart-only.exe)
  • /r - Activate recovery mode without prompting
    

[korisnik2007a]

(12-05-2024 10:09 PM)ToastyX Wrote:  

(12-05-2024 09:13 PM)korisnik2007a Wrote:  However, when I use CRU to make any kind of adjustments to my settings, and I try to reboot my pc my screen goes blank and the system is not responsive, I have to restart it.

I have noticed that if I physically unplug my second display (the HDMI HP one), the problem goes away and everything works fine. I've tried different driver versions (newer ones), and they all acted the same.

It's an NVIDIA driver bug. Their driver is hanging on boot when an EDID override is present with multiple displays connected, but it doesn't always happen. You should report the issue to NVIDIA.

Thank you for replying! I'll try to report it to them. Once again thanks for the app!

[LoveTilapia]

Hello friends,

I am trying to test if my cable is good quality. I am on an AMD 7900xt. If I set CRU to the following settings, will this properly disable DSC and run the full 3840x2160 144hz 10bit @ 40gigabit to my display? Is there some way to check if DSC is running on AMD ?

I know my display can handle the 48gbit on hdmi 2.1.